Structural Components: Foundation, Floor Structure, Wall Structure, Ceiling Structure, Roof Structure

Roofing System: Roof Style, Roof Coverings, Roof Flashings, Skylights, Chimneys, Roof Drainage System and Method of Inspection

Exterior Components: Site Grading, Retaining Walls, Entry Driveway, Walkways and Patios, Fencing, Porches, Decks, Steps, Railings, Wall Coverings, Eaves, Soffits, Fascias, Exterior Doors, Window/Door Frames and Trim

Electrical System: Service Type, Main Panel, Auxiliary Panels, Branch Circuit Wiring, Outlets, Switches, Lighting, Smoke Detectors 

Heating System: Type of Heating System, Venting, Heat Distribution Methods, Filter, Thermostat

Cooling System: Method of Installation, Electrical, Observed Refrigerant Lines, Condensate Discharge Method

Insulation / Ventilation: Observed Insulation and the Location of Exhaust, Foundation Attic and Mechanical Ventilation Locations 

Plumbing System: Water Supply Source, Service Pipe to Structure, Supply Piping, Waste, Drain and Vent Piping, Gas Meter and Observed Piping, Water Heater   

Interior Components: Wall Materials, Ceiling Materials, Floor Surfaces, Window Types & Glazing, Interior and Exterior Doors, Interior Stairs, Wet Bar, Cabinets

Kitchen and Laundry: Counters, Cabinets, Sinks, Appliances, Ventilation, Laundry Hookups and Condition 

Bathrooms: Toilet, Bidet, Sinks, Counters Cabinets, Bath tub, Shower, Ventilation, Heating

Garage / Carport: Structure, Roof System, Floor Foundation, Interior, Ventilation, Vehicle Door, Door to Interior, Exterior Side Door, Electrical 

Fireplace: Firebox Condition, Damper, Surround, Hearth, Gas

Pool, Spa and Water Features: These components are subcontracted to a licensed pool contractor. The average inspection time for a pool and spa by a licensed pool contractor is 2.5 - 3.5 hours, depending on size and complexity of systems. Complex systems with water features can take an average of 3.5 - 6 hours.